HOW TO CLEAN THE AXLE
FOR THE E-Z ROLL WHEELS

[Recommended approximately every 6 months-depending on usage]

1. Remove the snap ring from one end of the axle and save.download movies, dvd download, camel tobacco, download mp3, download mp3 online
   
2. Remove axle from wheel assembly by sliding it through the wheel and bushings.
   
3. Clean the axle with rubbing alcohol and a scotch pad.
   
4. STP additive oil treatment can be used on the axle by touching your index finger in the oil and putting a light film on the axle;  do NOT put any chemical in the wheel’s oilite.
   
5. Reassemble the wheel assembly in the reverse order.
   
6. Before turning the loading car upright, spin each wheel to check for ease of movement (see Note 1)
   

NOTE:

  1. When the wheel assembly is installed--spin the wheel to make sure it will roll freely. Sometimes the flanges that hold the wheel are squeezed against the wheel and constrict the movement. Make sure the flanges are perpendicular to the frame assembly so as not to pinch the wheels against the bushings.

  2. A common problem that affects the smooth movement of the loading car, is the alignment of the transfer carriage rails. The rails should be (from the inside dimension) 13” +/- 1/16”. The rails inside the sterilizer should also be the same dimension. The rail guides in the front of the chamber may move from the rails of the transfer carriages hitting against them. This can cause your loading car or transfer carriage to misalign. (If your staff cannot correct these problems, call SRS for more information.)

 Thank you for purchasing the SRS’ E-Z Roll Wheels. 
If you have any questions, please contact us

  Peter G. Walczak, President                 Sandra J. Walczak, Vice President